693.932 PEOPLE
| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Sivaswamy, Giribaskar
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (15/15 displayed)
- 2023Effect of heat treatments on microstructure and mechanical properties of low-cost Ti-6Al-4V alloy produced by thermo-mechanical powder consolidation routecitations
- 2023Miniaturised experimental simulation of open-die forgingcitations
- 2022An innovative constitutive material model for predicting high temperature flow behaviour of inconel 625 alloycitations
- 2022An analysis of the forgeability of Ti-10V-2Fe-3Al β titanium alloy using a combined Estrin Mecking and Avrami material constitutive modelcitations
- 2021A novel cyclic thermal treatment for enhanced globularisation kinetics in Ti-6Al-4V alloycitations
- 2021Effect of texture and mechanical anisotropy on flow behaviour in Ti-6Al-4V alloy under superplastic forming conditionscitations
- 2021A new route for developing ultrafine-grained Al alloy strips using repetitive bending under tensioncitations
- 2020Formability of AA-7075 sheets subjected to repetitive bending under tension
- 2020Mechanical response and microstructure evolution of commercially pure titanium subjected to repetitive bending under tensioncitations
- 2018Design and validation of a fixture for positive incremental sheet formingcitations
- 2018Effect of deformation-induced adiabatic heating on microstructure evolution during open-die screw press forging of Ti-6Al-4V.
- 2017Effect of incremental equal channel angular pressing (I-ECAP) on the microstructural characteristics and mechanical behaviour of commercially pure titaniumcitations
- 2017Microstructure and mechanical properties of Al-1050 during incremental ECAPcitations
- 2014Complex Incremental Sheet Forming Using Back Die Support on Aluminium 2024, 5083 and 7075 alloyscitations
- 2014Improvement in ductility in commercially pure titanium alloys by stress relaxation at room temperaturecitations
Places of action
| Organizations | Location | People |
|---|