| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Wolverson, Daniel
University of Bath
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (23/23 displayed)
- 2024Porous Structure Enhances the Longitudinal Piezoelectric Coefficient and Electromechanical Coupling Coefficient of Lead-Free (Ba0.85Ca0.15)(Zr0.1Ti0.9)O3citations
- 2024Spin-order-dependent magneto-elastic interactions in two dimensional antiferromagnetic MnPSe3 observed through Raman spectroscopycitations
- 2024Porous structure enhances the longitudinal piezoelectric coefficient and electromechanical coupling coefficient of lead‐free (Ba 0.85 Ca 0.15 )(Zr 0.1 Ti 0.9 )O 3citations
- 2023Exploring the Charge Density Wave Phase of 1T-TaSe2citations
- 2020Excitonic and lattice contributions to the charge density wave in 1T-TiSe2 revealed by a phonon bottleneckcitations
- 2020Phase behavior and substitution limit of mixed cesium-formamidinium lead triiodide perovskitescitations
- 2018Investigating nanostructures in carbon fibres using Raman spectroscopycitations
- 2017Strain-induced phonon shifts in tungsten disulfide nanoplatelets and nanotubescitations
- 2017Interfacial control in graphene- and transition metal dichalcogenide-polymer nanocomposites
- 2017Electronic band structure of ReS 2 by high-resolution angle-resolved photoemission spectroscopycitations
- 2017Electronic bandstructure and van der Waals coupling of ReSe2 revealed by high-resolution angle-resolved photoemission spectroscopycitations
- 2017Electronic band structure of ReS2 by high-resolution angle-resolved photoemission spectroscopycitations
- 2016Strain-induced phonon shifts in tungsten disulfide nanoplatelets and nanotubescitations
- 2016A comparison of the micromechanics of graphene- and transition metal dichalcogenide-nanocomposites
- 2014Raman spectra of monolayer, few-layer, and bulk ReSe 2 :An anisotropic layered semiconductorcitations
- 2014Raman spectra of monolayer, few-layer, and bulk ReSe2citations
- 2013Investigation of the sp3 structure of carbon fibres uUsing Uv-Raman spectroscopycitations
- 2012Porous silicon nanocrystals in a silica aerogel matrixcitations
- 2010Excitons in motion in II-VI semiconductorscitations
- 2010Carbon nanoparticle surface functionalisation: converting negatively charged sulfonate to positively charged sulfonamidecitations
- 2008Coherent Raman detected electron spin resonance spectroscopy of metalloproteins: linking electron spin resonance and magnetic circular dichroismcitations
- 2008Thin-film modified electrodes with reconstituted cellulose-PDDAC films for the accumulation and detection of triclosancitations
- 2000Band structure parameters of quaternary phosphide semiconductor alloys investigated by magneto-optical spectroscopy
Places of action
| Organizations | Location | People |
|---|
article
Porous structure enhances the longitudinal piezoelectric coefficient and electromechanical coupling coefficient of lead‐free (Ba 0.85 Ca 0.15 )(Zr 0.1 Ti 0.9 )O 3
Abstract
The introduction of porosity into ferroelectric ceramics can decrease the effective permittivity, thereby enhancing the open circuit voltage and electrical energy generated by the direct piezoelectric effect. However, the decrease in the longitudinal piezoelectric coefficient (d33) with increasing porosity levels currently limiting the range of pore fractions that can be employed. By introducing aligned lamellar pores into (Ba0.85Ca0.15)(Zr0.1Ti0.9)O3, this paper demonstrates an unusual 22–41% enhancement in the d33 compared to its dense counterpart. This unique combination of high d33 and a low permittivity leads to a significantly improved voltage coefficient (g33), energy harvesting figure of merit (FoM33) and electromechanical coupling coefficient ( k 33 2 $k_{33}^2$ ). The underlying mechanism for the improved properties is demonstrated to be a synergy between the low defect concentration and high internal polarizing field within the porous lamellar structure. This work provides insights into the design of porous ferroelectrics for applications related to sensors, energy harvesters, and actuators.