People | Locations | Statistics |
---|---|---|
Naji, M. |
| |
Motta, Antonella |
| |
Aletan, Dirar |
| |
Mohamed, Tarek |
| |
Ertürk, Emre |
| |
Taccardi, Nicola |
| |
Kononenko, Denys |
| |
Petrov, R. H. | Madrid |
|
Alshaaer, Mazen | Brussels |
|
Bih, L. |
| |
Casati, R. |
| |
Muller, Hermance |
| |
Kočí, Jan | Prague |
|
Šuljagić, Marija |
| |
Kalteremidou, Kalliopi-Artemi | Brussels |
|
Azam, Siraj |
| |
Ospanova, Alyiya |
| |
Blanpain, Bart |
| |
Ali, M. A. |
| |
Popa, V. |
| |
Rančić, M. |
| |
Ollier, Nadège |
| |
Azevedo, Nuno Monteiro |
| |
Landes, Michael |
| |
Rignanese, Gian-Marco |
|
Banford, A.
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (2/2 displayed)
Places of action
Organizations | Location | People |
---|
document
Towards the decontamination of plutonium contaminated bricks
Abstract
<p>There is a need for the decontamination of a number of plutonium-contaminated bricks encountered in a legacy BUTEX reprocessing plant on Sellafield site in the UK. Documentary review has indicated that the source of the contamination was a 8 mol dm<sup>-3</sup> nitric acid process stream containing 10 mmol dm<sup>-3</sup> of Pu in either the (III) or (IV) oxidation state. Here we have sought to emulate the behaviour of Pu(III) by treatment of fired clay brick surfaces with a solution of 10 mmol dm<sup>-3</sup> Ce(III) nitrate in 8 mol dm<sup>-3</sup> nitric acid. XRD, porosimetry and EDX measurements of the untreated bricks reveal them to be comprised of low porosity silica and aluminosilicate phases with a surface layer of a low-Si content Al-C-N oxide derived from the atmosphere of the kiln in which the bricks were fired. Depth profiling after an initial 6 week acid soak reveals that the acid penetrates <10 mm into the brick. SEM/EDX analysis reveals that acid treatment significantly roughens the brick surface due to dissolution the above described Al-C-N oxide layer. The EDX data also shows that virtually no Ce is retained as tenacious contamination at the brick surface; this may be due to a either a mass action/kinetic effect or taken to indicate that trivalent Ce(III) is less likely to absorb at the crystalline silica/aluminosilicate surface of the brick than its more easily hydrolysable tetravalent equivalent. Preliminary higher-resolution EDX analysis indicates that small quantities of Ce(III) can be detected in pores or cracks on the surface of acid-treated brick samples. This suggests that Ce(III) may be non-tenaciously sequestered into surface defects - and that a simple salt wash may be sufficient to remove it. Based on the above observations, potential decontamination strategies are discussed and future studies outlined.</p>