• Booth, Andrew
• Plaza, Floren
• Xing, Jeff

Abstract

Disposal of mud and ash, particularly in wet weather conditions, is a significant expense for mills.This paper reports on one part of a process to pelletise mud and ash, aimed at making mud and ash more attractive to growers across entire mill districts.The full process is described in a separate paper.The part described in this paper involves re-constituting mud cake from the filter station at Tully Mill and processing it in a decanter centrifuge. The material produced by re-constituting and centrifuging is drier and made up of separate particles.The material needs to mix easily with boiler ash, and the mixture needs to be fed easily into a flue gas drier to be dried to low moisture. The results achieved with the particular characteristics of Tully Mill rotary vacuum filter cake are presented.It was found that an internal rotor with a 20º beach was not adequate to process re-constituted rotary vacuum filter mud.A rotor with a 10º beach worked much more successfully.A total of four tonnes of centrifuged mud with a moisture content ranging from 60% to 65% was produced.It was found that the torque, flocculant rate and dose rate had a statistically significant effect on the moisture content.Feed rate did not have a noticeable impact on the moisture content by itself but torque had a much larger impact on the moisture content at the low feed rate than at the high feed rate.These results indicated that the moisture content of the mud can most likely be reduced with low feed rate, low flocculant rate, high dose rate and high torque. One issue that is believed to affect the operation of a decanter centrifuge was the large quantity of long bagasse fibres in the rotary vacuum filter mud.It is likely that the long fibres limited the throughput of the centrifuge and the moisture achieved.

Topics

• impedance spectroscopy