| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Ahmed, F.
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (15/15 displayed)
- 2021High-Strouhal-number pulsatile flow in a curved pipe
- 2016Combustion of fuel blends containing digestate pyrolysis oil in a multi-cylinder compression ignition enginecitations
- 2015Study of the effect of additives on magnetic and dielectric properties of M-type Sr-hexaferrites
- 2013Structural and magnetization behaviors of Ni substituted Li-Mg ferrites
- 2013Optical, electrical and thermal properties of jute and glass fiber reinforced LDPE composites
- 2012Comparative study of physical and elastic properties of jute and glass fiber reinforced LDPE composites
- 2012Magnetic and dielectric properties of M-type Sr-hexaferrites with the addition of calcium oxide and silicon-di-oxidecitations
- 2012Effect of Ca-substitution on the magnetic and dielectric properties of Mn-Zn ferritescitations
- 2012Investigation of magnetic, dielectric and electrical properties of Ba-hexaferritescitations
- 2012Study of physical, mechanical and thermal properties of unidirectional jute fiber reinforced PVC film composites
- 2012Physical, optical and thermal properties of graphite and talc filler reinforced polypropylene (PP) composites
- 2012Study of the effect of rare-earth oxide addition on the magnetic and dielectric properties of Sr-hexaferrites
- 2012Elastic and electrical properties of graphite and talc filler reinforced polypropylene (PP) composites
- 2011Stress evolution and cracking of crystalline diamond thin films on ductile titanium substrate: Analysis by micro-Raman spectroscopy and analytical modellingcitations
- 2009In-situ tensile testing of crystalline diamond coatings using Raman spectroscopycitations
Places of action
| Organizations | Location | People |
|---|
article
Physical, optical and thermal properties of graphite and talc filler reinforced polypropylene (PP) composites
Abstract
Graphite filler reinforced polypropylene (PP) composites and talc filler reinforced PP composites were prepared by compression molding at 160⁰ C. Physical, optical and thermal properties were studied. Bulk density of test materials increased with the fillers content. The composites show good optical properties. Absorbance decreases with the increase of wavelength and the highest absorbance peak was found near about 200 nm. Their thermal stability has also been studied. The results reveal that the addition of 5 wt.% of graphite or talc improves the thermal stability. There is an initial DTA peak for both PP-graphite and PP-talc composites. Thermal analysis of PP-graphite filler composites and PP-talc filler composites show that thermal degradation of PP sheet starts ahead of composites. Dynamic mechanical analysis shows high elasticity and low energy loss both for 5% of PP-graphite and PP-talc composites. All of these results indicated that PP-graphite composites are better than the PP-talc composites.