| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Ulewicz, Robert
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (10/10 displayed)
- 2023Influence of TiN Coating on the Drawing Force and Friction Coefficient in the Deep Drawing Process of AlMg4.5Mn0.7 Thin Sheetscitations
- 2022Analysis of Filler Metals Influence on Quality of Hard-Faced Surfaces of Gears Based on Tests in Experimental and Operating Conditionscitations
- 2021Influence of different hard-facing procedures on quality of surfaces of regenerated gearscitations
- 2017The effect of alloying method on the structure and properties of sintered stainless steelcitations
- 2016Influence of selected technological factors on fatigue strength
- 2015Influence of Electrodeposited Coatings on Ultra-High-Cycle Fatigue Life of S235 Structural Steelcitations
- 2014Structure and mechanical properties of fine-grained steelscitations
- 2014The impact of welding wire on the mechanical properties of welded joints
- 2013Fatigue testing structural steel as a factor of safety of technical facilities maintenance
- 2013DEPENDANCE BETWEEN CHARGE COMPOSITION AND FATIGUE PROPERTIES OF NODULAR CAST IRONS
Places of action
| Organizations | Location | People |
|---|
article
DEPENDANCE BETWEEN CHARGE COMPOSITION AND FATIGUE PROPERTIES OF NODULAR CAST IRONS
Abstract
The contribution deals with comparison of microstructure and fatigue properties of synthetic nodular cast irons. The basic charge of experimental meltages was formed by the different ratio of pig iron and steel scrap. The chemical composition of individual meltages was regulated alternatively by carburizer and ferrosilicon (FeSi) or metallurgical silicon carbide (SiC). The fatigue tests were run at high-frequency sinusoidal cyclic push-pull loading (frequency f » 20 kHz, load ratio R = –1, temperature T = 20 ± 5 °C) using the ultrasonic testing equipment KAUP-ZU. The paper shows the influence of charge composition on microstructure, fatigue properties and micromechanisms of failure. ; Stanisław Borkowski