| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Tosha, Katsuji
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (1/1 displayed)
Places of action
| Organizations | Location | People |
|---|
article
Effect of shot peening on surface integrity-influence of low temperature heating
Abstract
The effect of shot peening on surface integrity was described. After shot peening was performed tor carbon steel under several conditions with steel shot, peened materials were heat-treated at various temperatures and times (100-600°C, 15-240 min), and then hardness, half width and surface residual stress were measured. The following results are obtained: (1) non-affected layer induces compressive residual stresses on the peened surface and surface layer, (2) hardness increases after heating at 200-400°C, but decreases in case of 600°C, (3) compressive residual stresses decrease after all heat treatments, (4) microstructure may be recovered by heat treatment at low temperature.