| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Duarte, Isabel
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (12/12 displayed)
- 2024Insights into morphology and mechanical properties of architected interpenetrating aluminum-alumina compositescitations
- 2024Elaboration and experimental characterizations of copper-filled polyamide micro-composites for tribological applicationscitations
- 2023On the Structural, Thermal, Micromechanical and Tribological Characterizations of Cu-Filled Acrylonitrile Butadiene Styrene Micro-Compositescitations
- 2022Hybrid structures for Achilles' tendon repaircitations
- 2022Organic acid cross-linked 3D printed cellulose nanocomposite bioscaffolds with controlled porosity, mechanical strength, and biocompatibilitycitations
- 2022The influence of precipitation hardening on the damping capacity in Al–Si–Mg cast components at different strain amplitudescitations
- 2020Bacterial cellulose/graphene oxide aerogels with enhanced dimensional and thermal stability
- 2018Axial crush behaviour of the aluminium alloy in-situ foam filled tubes with very low wall thicknesscitations
- 2016Compressive behaviour of unconstrained and constrained integral-skin closed-cell aluminium foamcitations
- 2016Composite and Nanocomposite Metal Foamscitations
- 20142D quantitative analysis of metal foaming kinetics by hot-stage microscopycitations
- 2000A study of aluminium foam formation - Kinetics and microstructure
Places of action
| Organizations | Location | People |
|---|
article
A study of aluminium foam formation - Kinetics and microstructure
Abstract
Aluminium foams were produced by applying the powder compact melting method, i.e. by mixing metal powders and powdered gas-releasing blowing agents and pressing them to a foamable precursor material after this. The resulting precursor was then foamed by heating it up to above its melting point inside an "expandometer", which allowed for the volume and temperature to be measured throughout the entire process. The present studies comprise the effects of the aluminium alloy composition (AlSi7 and 6061), some of the pressing parameters of the foamable precursor material, the foaming temperature and the heating rate during foaming on the expansion behaviour of the foam. Moreover, the morphological and microstructural evolution of metal foams is investigated.