| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Piska, Miroslav
Brno University of Technology
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (10/10 displayed)
- 2023ON THE EFFECT OF ADVANCED PVD COATING ON PERFORMANCE OF CUTTING DIES IN AUSTENITIC STEEL
- 2021THE MACHINABILITY OF INC 718 BY CERAMIC INSERTS
- 2021ON THE EFFECTIVE SUBSTITUTION OF TURNING BY PERIPHERAL MILLING
- 2012Hole quality and burr reduction in drilling aluminium sheetscitations
- 2012Hole quality and burr reduction in drilling aluminium sheetscitations
- 2011Hole quality and burr reduction in drilling aluminium sheets
- 2011Hole quality and burr reduction in drilling aluminium sheets
- 2010On the Application of the PVD Hard Coatings for Ball Milling of Shaped Surfaces
- 2008Investigation on Capability of Reaming Process using Minimal Quantity Lubrication
- 2008Investigation on Capability of Reaming Process using Minimal Quantity Lubrication
Places of action
| Organizations | Location | People |
|---|
article
On the Application of the PVD Hard Coatings for Ball Milling of Shaped Surfaces
Abstract
Force load analysis is a usual procedure of current cutting tool testing in not only ball end milling but in general machining. This paper is aimed to force load analysis of the cutting tool when the HSS ball end milling is performed onto an alumina alloy. A variation of the cutting tool force loading has been observed when a tilt of the tool was set perpendicularly to the direction of the feed speed vector in the range 0-20deg and cutting conditions were kept constant. In the first part of the study, some uncoated HSS ball milling tools have been used to exclude an influence of PVD coating and its disperse in quality. In the second part of the project the PVD coatings on the base of (TixAl1-x)N and TiB2 have been successively applied. However, the main objective of the research was to quantify other cutting phenomena also, like the chip formation, roughness of the machined surface as they present a key role in the complex surface machining for moulds.