| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Poulachon, Gérard
Laboratoire Bourguignon des Matériaux et Procédés
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (5/5 displayed)
- 2017Microstructural investigations of the white and deformed layers close to the turned surface of Ti-6Al-4Vcitations
- 2016Flank wear prediction in milling AISI 4140 based on cutting forces PCA for different cutting edge preparationscitations
- 2014Tool wear monitoring and hole surface quality during CFRP drillingcitations
- 2013Process Mechanics and Surface Integrity Induced by Dry and Cryogenic Machining of AZ31B-O Magnesium Alloy
- 2006An Experimental and Analytical Method for Investigating Plastic Flow in Form Tapping
Places of action
| Organizations | Location | People |
|---|
conferencepaper
Process Mechanics and Surface Integrity Induced by Dry and Cryogenic Machining of AZ31B-O Magnesium Alloy
Abstract
The corrosion resistance of magnesium alloys depends mainly on its surface integrity. Previous experimental studies have shown that machining can induces small (nano-scale) grain size, compressive residual stresses and basal plane crystallographic texture, which significantly improve the corrosion resistance of magnesium alloy. These studies have focused on the positive effects of cryogenic cooling and tool edge radius preparation. In this paper, the influence of a wide range of cutting process parameters (including cut-ting speed, feed, tool rake angle, tool edge radius and cooling conditions) acting on the cutting mechanics and surface integrity produced during machining of AZ31B-O magnesium alloy have been studied experimentally and numerically.