| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Goliński, Jacek
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (5/5 displayed)
- 2020Similar and dissimilar welds of ultrafine grained aluminium obtained by friction stir weldingcitations
- 2017Ultrafine-Grained Plates of Al-Mg-Si Alloy Obtained by Incremental Equal Channel Angular Pressing: Microstructure and Mechanical Propertiescitations
- 2015Influence of grain size on the corrosion resistance of aluminium alloy Al 6060
- 2015Microstructure evolution in aluminium 6060 during Incremental ECAP
- 2015Microstructure and mechanical properties of friction stir welded joints made from ultrafine grained aluminium 1050citations
Places of action
| Organizations | Location | People |
|---|
document
Influence of grain size on the corrosion resistance of aluminium alloy Al 6060
Abstract
The purpose of this paper is to consider the relationship between corrosion resistance and grain size in aluminium alloy 6060. Grain size reduction down to about 500 nm was obtained by severe plastic deformation, performed using Incremental Equal Channel Angular Pressing (I-ECAP), which was recently developed as an efficient method of production ultrafine grained both sheet metaland thick plates. Samples investigated in terms of corrosion resistance have been deformed in I-ECAP todifferent value of true strain. The results were compared to those obtained for coarse grained, undeformed material. All samples have been investigated by potentiodynamic and potentiostatic polarization. Results of corrosion resistancewere correlated with materials microstructures. Not only average grain size but also size distribution was taken into consideration. Differences in the corrosion morphology between specimens with varying degrees of processing have been found. This was attributed to grain boundaries rearrangement which was induced during deformation