• Skorupińska, Ewa
• Sydor, Maciej
• Wiaderek, Krzysztof

Abstract

<jats:p>T-nuts are factory installed in the holes of the ready-to-assemble furniture components. There is a risk that the t-nut spontaneously falls out during transport or storage and get lost; the t-nut can also be pushed into inaccessible spaces during assembly. These complications can make furniture assembly impossible. For this reason, sufficient force to hold the t-nut in the hole is essential. The article presents the test results of the forces holding the t-nuts in five furniture materials (softwood, Oriented Strand Board, plywood, and particleboard in two variants). The M6 t-nuts with four prongs were installed in predrilled 8 mm holes. The resistance to withdrawal of the t-nuts was measured with a universal testing machine. The tested materials could be divided into three groups in terms of the risk of the t-nut falling out: softwood and plywood – low risk, F = 1113.2-1158.0 N; OSB and particleboard – moderate risk, F = 592.3-645.5 N, particleboard with a pad – high risk, F = 645.5 N. The results show that the withdrawal resistance is not correlated with the density of the wood material, and that it decreased with the degree of wood material processing – the less processed the material, the greater the resistance to withdrawal of the t-nuts.</jats:p>

Topics

• density
• impedance spectroscopy
• laser emission spectroscopy
• wood