| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Nakajima, Hideo
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (11/11 displayed)
- 2012On the Anisotropy of Lotus‐Type Porous Coppercitations
- 2010Deformation of Lotus-Type Porous Copper in Rollingcitations
- 2010Effect of Transfer Velocity on Porosity of Lotus-Type Porous Aluminum Fabricated by Continuous Casting Techniquecitations
- 2010Fabrication of Lotus-Type Porous Iron by Thermal Decomposition Method
- 2010Investigation of the Mechanical Properties of Lotus-Type Porous Carbon Steel Made by Continuous Zone Melting Techniquecitations
- 2010Fabrication of Lotus-Type Porous Al-Ti Alloys Using the Continuous Casting Technique
- 2010Strain rate dependence of anisotropic compression behavior in porous iron with unidirectional porescitations
- 2010Effect of Addition of NiO Powder on Pore Formation in Lotus-Type Porous Carbon Steel Fabricated by Continuous Castingcitations
- 2008Magnetization process of lotus-type porous metalscitations
- 2006Compressive properties of lotus-type porous stainless steelcitations
- 2005Anisotropic electrical conductivity of lotus-type porous nickelcitations
Places of action
| Organizations | Location | People |
|---|
article
Fabrication of Lotus-Type Porous Iron by Thermal Decomposition Method
Abstract
<jats:p>Lotus-type porous iron was fabricated by continuous zone melting technique through thermal decomposition of chromium nitride(Cr1.18N). Nitrogen dissolves into the molten iron through thermal decomposition of Cr1.18N. When the molten iron is solidified in one direction, insoluble nitrogen forms the directional gas pores aligned along the solidification direction. The porosity increases with increasing transfer velocity. For most of lotus metals fabricated by pressurized gas method, the porosity does not change with the transfer velocity owing to constant gas solubility in liquid and solid phase. On the other hand, the porosity of lotus metal fabricated by thermal decomposition method depends on the transfer velocity. This difference is attributed to the decomposition behavior of gas compound dependent upon the heating rate.</jats:p>