| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Nakajima, Hideo
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (11/11 displayed)
- 2012On the Anisotropy of Lotus‐Type Porous Coppercitations
- 2010Deformation of Lotus-Type Porous Copper in Rollingcitations
- 2010Effect of Transfer Velocity on Porosity of Lotus-Type Porous Aluminum Fabricated by Continuous Casting Techniquecitations
- 2010Fabrication of Lotus-Type Porous Iron by Thermal Decomposition Method
- 2010Investigation of the Mechanical Properties of Lotus-Type Porous Carbon Steel Made by Continuous Zone Melting Techniquecitations
- 2010Fabrication of Lotus-Type Porous Al-Ti Alloys Using the Continuous Casting Technique
- 2010Strain rate dependence of anisotropic compression behavior in porous iron with unidirectional porescitations
- 2010Effect of Addition of NiO Powder on Pore Formation in Lotus-Type Porous Carbon Steel Fabricated by Continuous Castingcitations
- 2008Magnetization process of lotus-type porous metalscitations
- 2006Compressive properties of lotus-type porous stainless steelcitations
- 2005Anisotropic electrical conductivity of lotus-type porous nickelcitations
Places of action
| Organizations | Location | People |
|---|
article
Investigation of the Mechanical Properties of Lotus-Type Porous Carbon Steel Made by Continuous Zone Melting Technique
Abstract
<jats:p>The lotus-type porous carbon steel with cylindrical pores has been fabricated by continuous zone melting technique in pressurized mixture of hydrogen and helium gases. In order to investigate the mechanical properties, the tensile and compression tests were carried out. The ultimate tensile strength of the specimen with cylindrical pores parallel to the solidification direction is lower than the estimated value assuming that the strength is decreased in proportion to decreasing cross section area of the specimen, while the yield strength is higher than that estimated. The compressive yield strength is also higher than that estimated. The increase in yield strength is attributed to the precipitation strengthening. The tensile strength is increased by quenching and tempering, while the elongation decreases. Such mechanical properties are discussed in terms of microstructureal analysis. Furthermore, simulations of the mechanical properties by FEM analysis were carried out.</jats:p>