• Salwa, Piotr
• Goryczka, Tomasz

Abstract

A high-energy ball milling technique was used for production of the equiatomic NiTi alloy. The grinding batch was prepared in two quantities of 10 and 20 g. The alloy was produced using various grinding times. Scanning electron microscopy, X-ray diffraction, hardness measurement and differential scanning calorimetry were used for materials characterization at various milling stages. The produced alloy was studied by means of microstructure, chemical and phase composition, average grain and crystallite size, crystal lattice parameters and microstrains. Increasing the batch mass to 20 g and extending the grinding time to 140 h caused the increase in the average size of the agglomerates to 700 m while the average crystallites size was reduced to a few nanometers. Microstrains were also reduced following elongation of milling time. Moreover, when the grinding time is extended, the amount of the monoclinic phase increases at the expense of the body-centered cubic one—precursors of crystalline, the B2 parent phase and the B190 martensite. Crystallization takes place as a multistage process, however, at temperatures below 600 C. After crystallization, the reversible martensitic transformation occurred with the highest enthalpy value—4 or 5 J/g after 120 and 140 h milling, respectively.

Topics

• impedance spectroscopy
• grain
• phase
• scanning electron microscopy
• x-ray diffraction
• milling
• hardness
• differential scanning calorimetry
• ball milling
• ball milling
• crystallization
• crystalline lattice