• Figiel, Pawel
• Kochmanska, Agnieszka
• Kwiatkowska, Magdalena
• Maziarz, Wojciech
• Chylińska, Renata
• Niemczyk, Agata
• Rogal, Łukasz
• Fryska, Sebastian
• Baranowska, Jolanta
• Słowik, Justyna
• Kwiatkowski, Konrad
• Kochmański, Paweł
• Dybowski, Konrad

Abstract

<jats:p>This study presents research results concerning the vacuum carburizing of four steel grades, specifically conforming to European standards 1.7243, 1.6587, 1.5920, and 1.3532. The experimental specimens exhibited variations primarily in nickel content, ranging from 0 to approximately 3.8 wt. %. As a comparative reference, gas carburizing was also conducted on the 1.3532 grade, which had the highest nickel content. Comprehensive structural analysis was carried out on the resultant carburized layers using a variety of techniques, such as optical and electron scanning, transmission microscopy, and X-ray diffraction. Additionally, mechanical properties such as hardness and fatigue strength were assessed. Fatigue strength evaluation was performed on un-notched samples having a circular cross-section with a diameter of 12 mm. Testing was executed via a three-point bending setup subjected to sinusoidally varying stresses ranging from 0 to maximum stress levels. The carburized layers produced had effective thicknesses from approximately 0.8 to 1.4 mm, surface hardness levels in the range of 600 to 700 HV, and estimated retained austenite contents from 10 to 20 vol%. The observed fatigue strength values for the layers varied within the range from 1000 to 1350 MPa. It was found that changing the processing method from gas carburizing, which induced internal oxidation phenomena, to vacuum carburizing improved the fatigue properties to a greater extent than increasing the nickel content of the steel.</jats:p>

Topics

• surface
• nickel
• x-ray diffraction
• strength
• steel
• fatigue
• hardness
• chemical composition
• microscopy