• Povoden-Karadeniz, Erwin
• Kreyca, Johannes
• Sobotka, Evelyn
• Poletti, Maria Cecilia

Abstract

<p>Microalloyed steels offer a good combination of desirable mechanical properties by fine-tuning grain growth and recrystallization dynamics while keeping the carbon content low for good weldability. In this work, the dislocation density evolution during hot rolling was correlated by materials modeling with flow curves. Single-hit compression tests at different temperatures and strain rates were performed with varying isothermal holding times prior to deformation to achieve different precipitation stages. On the basis of these experimental results, the dislocation density evolution was evaluated using a recently developed semi-empirical state-parameter model implemented in the software MatCalc. The yield stress at the beginning of the deformation σ₀, the initial strain hardening rate θ₀, and the saturation stress σ_∞—as derived from the experimental flow curves and corresponding Kocks plots—were used for the calibration of the model. The applicability for industrial processing of many microalloyed steels was assured by calibration of the model parameters as a function of temperature and strain rate. As a result, it turned out that a single set of empirical equations was sufficient to model all investigated microalloyed steels since the plastic stresses at high temperatures did not depend on the precipitation state.</p>

Topics

• density
• polymer
• Carbon
• grain
• steel
• dislocation
• compression test
• precipitation
• recrystallization
• grain growth
• carbon content
• hot rolling