• Lekatou, Angeliki G.
• Zurnadzhy, Vadym
• Pastukhova, Tatiana
• Chabak, Yuliia
• Kovaľ, Karol
• Efremenko, Bohdan
• Efremenko, Vasily
• Bogomol, Iurii
• Fedun, Victor
• Petryshynets, Ivan

Abstract

<jats:p>The structural features and nanoindentation/tribological properties of 316 stainless steel fabricated by conventional rolling and laser-based powder bed fusion (LPBF) were comparatively investigated regarding the effect of surface-pulsed plasma treatment (PPT). PPT was performed using an electrothermal axial plasma accelerator under a discharge voltage of 4.5 kV and a pulse duration of 1 ms. Optical microscopy, scanning electron microscopy, X-ray diffraction, nanoindentation measurements and tribological tests were applied to characterize the alloys. The LPBF steel presented almost the same modulus of elasticity and double the hardness of rolled steel. However, the LPBF steel manifested lower dry-sliding wear resistance compared with its wrought counterpart due to its porous structure and non-metallic inclusions. Conversely, LPBF steel showed three times higher wear resistance under sliding in simulated body fluid (SBF), as compared with wrought steel. PPT led to steel modification through surface melting to a depth of 22–26 μm, which resulted in a fine cellular structure. PPT moderately improved the dry-sliding wear resistance of LPBF steel by fusion of pores on its surface. On the other hand, PPT had almost no effect on the SBF-sliding wear response of the steel. The modification features were analyzed using a computer simulation of plasma-induced heating.</jats:p>

Topics

• porous
• pore
• surface
• stainless steel
• inclusion
• scanning electron microscopy
• x-ray diffraction
• simulation
• wear resistance
• mass spectrometry
• hardness
• nanoindentation
• elasticity
• optical microscopy
• powder bed fusion