• Asmael, Mohammed
• Hussain, Ghulam
• Heidarshenas, Behzad

Abstract

<p>The aim of this study was to develop a composite coating on 304 stainless steel employing a TIG (tungsten inert gas) process. Ti wire cored with graphite powder was used as the means of coating material. The process parameters were controlled to develop a coating with optimum characteristics (i.e., hardness and wear resistance). The microstructure of the coating was analyzed with SEM and XRD. It was found that both the hardness and the wear resistance increase as the current increases, while both of these properties decrease as travelling speed increases. It was found that the coated samples with composite layers were harder than the substrate and can range up to 1100 HV, almost 4.5 times higher than the hardness of 304 stainless steel. Likewise, the wear resistance of the coating was observed to be 4.5 times higher than that of the substrate. The high performance of the coating, as revealed by microstructural analysis, was due to the formation of TiC and Cr₂₃C₆. The optimum conditions for producing the coating are thus proposed to include a 120 A current and a 3.17 mm/s travel speed.</p>

Topics

• microstructure
• stainless steel
• scanning electron microscopy
• x-ray diffraction
• wear resistance
• composite
• hardness
• tungsten
• wire