| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Kozior, Tomasz
Kielce University of Technology
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (3/3 displayed)
- 2024Influence of Textile Substrates on the Adhesion of PJM-Printed MED610 and Surface Morphology ; Vpliv tekstilnega substrata na adhezijo smole MED610, natisnjene s tehniko kapljičnega nanašanja PJM, in morfologija površinecitations
- 2022Comparative Analysis of Polymer Composites Produced by FFF and PJM 3D Printing and Electrospinning Technologies for Possible Filter Applicationscitations
- 2019Stabilization of Electrospun Nanofiber Mats Used for Filters by 3D Printingcitations
Places of action
| Organizations | Location | People |
|---|
article
Comparative Analysis of Polymer Composites Produced by FFF and PJM 3D Printing and Electrospinning Technologies for Possible Filter Applications
Abstract
<jats:p>Three-dimensional printing technologies are mainly used to build objects with complex shapes and geometry, largely prototypes, and thanks to the possibility of building very thin layers of material with small pores, electrospinning technology allows for the creation of structures with filtration properties, in particular very small particles. The combination of these technologies creates new possibilities for building complex-shape composites that have not been comprehensively tested so far. The article describes the results of research on composites manufactured by combining samples prepared with two 3D printing technologies, Fused Filament Fabrication (FFF) and Photo-Curing of Liquid Polymer Resins (PJM) in combination with electrospinning (ES) technology. The surface morphology of composites manufactured from biocompatible materials was investigated using confocal laser scanning microscopy (CLSM) and contact angle measurements, and chemical composition analysis was studied using Fourier transform infrared spectroscopy (FTIR). This approach to creating composites appears to be an alternative to developing research for filtration applications. The article presents basic research illustrating the quality of composites produced by combining two unconventional technologies: 3D printing and electrospinning (ES). The analysis of the research results showed clear differences in the structure of composites produced with the use of various 3D printing technologies. The CLSM analysis showed a much better orientation of the fibers in the MED610 + PAN/gelatin composite, and the measurement of the contact angle and its indirect interpretation also for this composite allows for the conclusion that it will be characterized by a higher value of adhesion force. Moreover, such composites could be used in the future for the construction of filtering devices and in medical applications.</jats:p>