| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Łada, Paula
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (8/8 displayed)
- 2020Manufacturing of ZrO2-Ni graded composites via centrifugal casting in the magnetic fieldcitations
- 2019Characterization of Alumina–Molybdenum Composites Prepared by Gel Casting Methodcitations
- 2018Microstructure and hardness of Al2O3-ZrO2-Ti composites
- 2018Sintering behavior and thermal expansion of zirconia–titanium compositescitations
- 2018Zirconia–Titanium Interface in Ceramic Based Compositecitations
- 2017The Formation of ZrO2–Ti Composites by Spark Plasma Sinteringcitations
- 2017Microstructure Characterization of Composite from ZrO2 – Ti Systemcitations
- 2016Fabrication of ZrO2-Ti composites by slip casting methodcitations
Places of action
| Organizations | Location | People |
|---|
article
Manufacturing of ZrO2-Ni graded composites via centrifugal casting in the magnetic field
Abstract
The paper presents the possibility of fabricating ceramic-metal composites by an innovative method of centrifugal slip casting in the magnetic field. It was examined whether the use of this method would allow obtaining a gradient concentration of metal particles in the ceramic matrix. In the applied technique, the horizontal rotation axis was used. The study investigated the effect of solid phase content on the properties and microstructure of the products. Water-based suspensions with 35, 40, 45 and 50 vol.% of solid-phase content were prepared with 10 vol.% additional of nickel powder. The viscosity of prepared slurries was considered. The gradient distribution of nickel particles in the zirconia matrix was observed on SEM. Vickers hardness of ZrO2-Ni composites has been measured. The research revealed that the physical properties depend on the volume fraction of solid content and increase as the volume of solid content increases.