| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Śnieżek, Lucjan
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (6/6 displayed)
- 2023The Influence of Process Parameters on the Low-Cycle Fatigue Properties of 316L Steel Parts Produced by Powder Bed Fusioncitations
- 2022Increasing the Mechanical Strength and Corrosion Resistance of Aluminum Alloy 7075 via Hydrostatic Extrusion and Agingcitations
- 2022The Influence of Heat Treatment on the Mechanical Properties and Corrosion Resistance of the Ultrafine-Grained AA7075 Obtained by Hydrostatic Extrusioncitations
- 2019Analysis of the microstructure of an AZ31/AA1050/AA2519 laminate produced using the explosive-welding methodcitations
- 2018Microstructure and fatigue life of Cp-Ti/316L bimetallic joints obtained by means of explosive weldingcitations
- 2016Mechanical and microstructural characteristics of Ti6Al4V/AA2519 and Ti6Al4V/AA1050/AA2519 laminates manufactured by explosive welding
Places of action
| Organizations | Location | People |
|---|
article
Microstructure and fatigue life of Cp-Ti/316L bimetallic joints obtained by means of explosive welding
Abstract
This paper describes a study of explosively welded, commercially pure titanium-stainless steel 316L plates. Following welding, the plates were heat-treated at the temperature of 600°C for 90 minutes. Examinations of the bond structure were carried out before and after heat treatment to investigate the processes taking place during explosive welding of materials. Observations were performed using light, scanning electron (SEM) and transmission electron microscopy (TEM). The mechanical properties were examined applying three-point bending tests with cyclic loads. Fractographic examination and hardness measurements were also performed. It has been found that the bonding zones are characterized by a specific microstructure, chemical composition and microhardness. The heat treatment used in the study increases the relative volume of brittle intermetallic phases, causing a reduction in fatigue strength of the joint.