| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Rodak, Kinga
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (8/8 displayed)
- 2024Tailoring the microstructure, mechanical properties, and electrical conductivity of Cu–0.7Mg alloy via Ca addition, heat treatment, and severe plastic deformationcitations
- 2023The influence of the heat generation during deformation on the mechanical properties and microstructure of the selected TWIP steelscitations
- 2023Microstructure, mechanical properties, and corrosion behavior of a biodegradable Zn-1.7Mg-1Ca alloy processed by KoBo extrusioncitations
- 2019Crystallographic Texture and Grain Refinement in the CuCr Alloy Deformed by SPD Method
- 2018Influence of heat treatment on the formation of ultrafine-grained structure of Al–Li alloys processed by SPDcitations
- 2017Cu-Cr and Cu-Fe Alloys Processed By New Severe Plastic Deformation : Microstructure and Propertiescitations
- 2015The Microstructure of AlSi7Mg Alloy in as Cast Conditioncitations
- 2010Studies of Cu after severe plastic deformationcitations
Places of action
| Organizations | Location | People |
|---|
article
Crystallographic Texture and Grain Refinement in the CuCr Alloy Deformed by SPD Method
Abstract
Microstructure and texture of the CuCr0.6 alloy processed by rolling with cyclic movement of rolls (RCMR) at room temperature were investigated. The RCMR processing was applied for the samples in different initial conditions in the solid solution followed by quenching into iced water at 1000oC for 3 h and in aging treatment conditions performed at 500oC for 2 h and at 700oC for 24 h. Application of the solution and aging processes prior to RCMR deformation results in the partial dissolution of Cr particles into the Cu matrix and precipitation of the second phase particles. RCMR processing with value of the total effective strain (εft) of 5 was introduced to the material. It was found that the RCMR method is effective in texture weakening. The obtained results revealed that there is a large similarity in texture orientations after RCMR processing independently of heat treatment conditions. Cyclic character of deformation leads to an incomplete transition of LAB to HAB.