| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Raupp-Pereira, F.
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (18/18 displayed)
- 2019Characterization of pulp and paper mill waste for the production of waste-based cementcitations
- 2018Wastes from pulp and paper mills - A review of generation and recycling alternativescitations
- 2018Structural Refinement by the Rietveld Method on Clinkers Obtained from Waste from Pulp and Paper Millscitations
- 2018Thermal characterization of hydrated eco-friendly clinkers produced from pulp and paper mill wastecitations
- 2017Waste-containing clinkers: Valorization of alternative mineral sources from pulp and paper millscitations
- 2016Life cycle assessment of the production of cement: A Brazilian case studycitations
- 2014The influence of porogene additives on the properties of mortars used to control the ambient moisturecitations
- 2014Development of porogene-containing mortars for levelling the indoor ambient moisturecitations
- 2008Al-27 and Si-29 NMR and XRD characterisation of clinkers: standard phases and new waste based formulationscitations
- 2008New waste based clinkers: Belite and lime formulationscitations
- 2007Effects of potable water filtration sludge on the rheological behaviour of one-coat plastering mortarscitations
- 2007Setting behaviour of waste-based cements estimated by impedance spectroscopy and temperature measurements
- 2006Light aggregates from industrial wastes | Aggregati leggeri da rifiuti industriali
- 2006Ceramic formulations prepared with industrial wastes and natural sub-productscitations
- 2005Lightweight aggregates based on industrial wastes
- 2005Cement formulations made of different wastes and natural sub-probucts
- 2005Refractory mortars based on industrial wastes
- 2005Lightweight expanded clays based on industrial wastes
Places of action
| Organizations | Location | People |
|---|
article
Thermal characterization of hydrated eco-friendly clinkers produced from pulp and paper mill waste
Abstract
<jats:p>Abstract Industrial wastes from pulp and paper mills are potentially useful materials to use as alternative materials in clinker production. In this study, eco-friendly clinkers were obtained using only waste as feedstock. Eco-friendly clinker with different C3S and C2S contents were produced and hydrated for 7 days at 40 °C, or for 28 and 90 days at room temperature. The potentialities of these waste and the products obtained were revealed through chemical (XRF), thermal (DTA/TG) and surface area (BET) analysis. For comparison, a common ordinary Portland cement (OPC) was tested. As expected, the hydration rate of formulations presenting higher C3S content was higher, generating higher amounts of Ca(OH)2. Furthermore, the amount of Portlandite formed was lower when compared to OPC.</jats:p>