• Doktor, Tomáš
• Kytýř, Daniel
• Jiroušek, Ondřej
• Fíla, Tomáš

Abstract

<jats:p>Presented paper deals with experimental study on compressive properties of auxetics with controlled stiffness of strut joints. The variable strut joints properties were simulated by adding extra amount of material in the struts’ intersection regions. Four groups of inverted honeycomb structures were prepared by multi-jet 3D printing and tested in quasi-static compression. The structure collapsed gradually, however after the first collapse, failure in entire cross-section occurred due to the brittle nature of the base material. The behavior up to the first collapse was consistent among the specimens within each group, while differed slightly subsequently. With higher reinforcement in the joints, results showed increasing stress at the first collapse (ultimate compressive stress) while the strain at the first collapse remained unchanged. The auxetic behaviour became less significant with increasing joints’ reinforcement.</jats:p>

Topics

• laser emission spectroscopy