• Singh, Narinder

Abstract

<jats:p> This research work highlights the thermomechanical investigations of silicon carbide (SiC) and aluminum oxide (Al<jats:sub>2</jats:sub>O<jats:sub>3</jats:sub>)–reinforced high-density polyethylene (HDPE)–based feed stock filament of commercial fused deposition modeling (FDM) setup. The recycled HDPE waste was collected (from domestic waste) and washed with water jet for removal of contamination in the first stage. After contamination removal, rheological and thermal behavior (melt flow index, melting temperature, decomposition and enthalpy, etc.) of the unreinforced and reinforced polymer matrix was observed. The SiC and Al<jats:sub>2</jats:sub>O<jats:sub>3</jats:sub> reinforcements in the HDPE matrix have been controlled by twin-screw extrusion process, followed by its processing on single-screw extrusion for preparation of FDM feed stock filament. The feed stock filament prepared by single-screw extruder was subjected to tensile test for mechanical properties (such as peak strength, peak load, and Young’s modulus). After ascertaining mechanical properties, multifactor optimization has been performed. Finally, scanning electron micrographs were obtained to understand the distribution of ceramic particles. This study highlights the detailed procedure for managing the polymer waste with improved mechanical properties by considering multifactor optimization. This will enhance the sustainability and also helps to develop low-cost, in-house FDM filament for possible applications as rapid tooling. </jats:p>

Topics

• Deposition
• density
• polymer
• melt
• extrusion
• aluminum oxide
• aluminium
• strength
• carbide
• Silicon
• decomposition
• melting temperature