| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Sen, Faruk
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (1/1 displayed)
Places of action
| Organizations | Location | People |
|---|
article
Failure analysis of laminated composite plates with two parallel pin-loaded holes
Abstract
<p>The aim of this study is to research the failure loads and failure modes of laminated woven-glass-polyester composite plates with two parallel circular holes, which are subjected to traction forces by two rigid pins. The failure behavior of two parallel pin-loaded composite plates has been observed both experimentally and numerically with different geometries and fiber orientations. While the plate width to hole diameter ratio (W/D) was held constant; the distance from the free edge of the plate to hole diameter ratio (E/D) was changed from 1 to 5, and the distance between two parallel holes to hole diameter ratio (M/D) was varied from 2 to 5. Two different ply rientations were also investigated as [0°]<sub>8</sub> and [0°<sub>2</sub>= 60°<sub>2</sub>/]<sub>s</sub>. In a numerical study, a three-dimensional finite element method (FEM) was used with the assistance of a LUSAS 13.6 finite element analysis program. Good agreement has been shown between experimental and numerical results.</p>