| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Singaravelu, Dinesh Kumar
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (6/6 displayed)
- 2021Parameters of Porosity and Compressive Strength-Based Optimization on Reinforced Aluminium from the Recycled Waste Automobile Framescitations
- 2021Optimization of Reinforced Aluminium Scraps from the Automobile Bumpers with Nickel and Magnesium Oxide in Stir Castingcitations
- 2021Improving the Mechanical Properties of Natural Fiber Composites of Hemp Fiber with Ramie and Banana Fiber through Compression Molding Methodcitations
- 2021Synthesis, Mechanical, and Tribological Performance Analysis of Stir-Casted AA7079: ZrO2 + Si3N4 Hybrid Composites by Taguchi Routecitations
- 2021Synthesis and Characterization of Polypropylene/Ramie Fiber with Hemp Fiber and Coir Fiber Natural Biopolymer Composite for Biomedical Applicationcitations
- 2019Hybrid Reinforced Composite Material from Garbage to Biomaterialscitations
Places of action
| Organizations | Location | People |
|---|
article
Parameters of Porosity and Compressive Strength-Based Optimization on Reinforced Aluminium from the Recycled Waste Automobile Frames
Abstract
<jats:p>Automobile industries were ready to recycle the waste old parts as well as the damaged parts of the old vehicles as much as possible. This study mainly focused on the recycling of the waste and damaged aluminium frames of the automobile bodies. These aluminium-based frames only collected the metal matrix composite created by reinforcement of 3% silicon carbide (SiC) and 3% high carbon steel. The stir casting method is chosen to make the composites. Optimization is done by Taguchi ANOVA technique. Three input parameters such as stir speed, time of squeeze, and the temperature of the preheating were considered. The outputs such as compressive strength and porosity were experimentally measured with the combination of nine (L9) experimental trails. The measured experimental results were analyzed and optimized with the help of Taguchi technique with different plots for clear identification. The optimized parameters based on low porosity and high compressive strength were recommended for conclusion.</jats:p>