• Kim, S.
• Turhan, A.
• Mench, M. M.
• Hussey, D. S.
• Jacobson, D. L.

Abstract

<jats:p>In this study, the effect of a controlled temperature gradient on water transport across a single fuel cell was quantitatively investigated using high-resolution neutron imaging. The direction of liquid water transport under isothermal and non-isothermal conditions was observed in both hydrophilic and hydrophobic diffusion media (DM). The change in distribution of liquid saturation with time revealed two different mechanisms of water transport; capillary driven flow and phase-change induced (PCI) flow, in which a water vapor concentration gradient is created by condensation at a colder location. This concentration gradient drives diffusion flow toward the colder location. A maximum liquid saturation plateau of <jats:italic>ca.</jats:italic> 30% was shown for all conditions tested, indicating a critical transition between pendular and funicular modes of liquid water storage was captured. Based on this, it is suggested that PCI-flow may be the main mode of liquid transport below this critical transition threshold, above which, capillary flow dominates. As expected, both average cell temperature and the magnitude of temperature gradient were shown to significantly affect the rate of condensation within the DM. Experimental results were compared with water saturation distribution model predictions from literature and show reasonable qualitative agreement. Finally, it was concluded that current available models significantly over predict vapor phase diffusive transport in saturated fuel cell media using a Bruggeman type model.</jats:p>

Topics

• impedance spectroscopy
• polymer
• phase