People | Locations | Statistics |
---|---|---|
Naji, M. |
| |
Motta, Antonella |
| |
Aletan, Dirar |
| |
Mohamed, Tarek |
| |
Ertürk, Emre |
| |
Taccardi, Nicola |
| |
Kononenko, Denys |
| |
Petrov, R. H. | Madrid |
|
Alshaaer, Mazen | Brussels |
|
Bih, L. |
| |
Casati, R. |
| |
Muller, Hermance |
| |
Kočí, Jan | Prague |
|
Šuljagić, Marija |
| |
Kalteremidou, Kalliopi-Artemi | Brussels |
|
Azam, Siraj |
| |
Ospanova, Alyiya |
| |
Blanpain, Bart |
| |
Ali, M. A. |
| |
Popa, V. |
| |
Rančić, M. |
| |
Ollier, Nadège |
| |
Azevedo, Nuno Monteiro |
| |
Landes, Michael |
| |
Rignanese, Gian-Marco |
|
Martyniuk, Mariusz
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (16/16 displayed)
- 2022Iron oxide-Palladium core-shell nanospheres for ferromagnetic resonance-based hydrogen gas sensingcitations
- 2022Application of a Microfabricated Microwave Resonator in a Co-Pd-Based Magnetic Hydrogen-Gas Sensorcitations
- 2018Effect of thermal annealing on stress relaxation and crystallisation of ion beam sputtered amorphous Si1-xGex thin filmscitations
- 2018MEMS-based Low SWaP solutions for multi/hyperspectral infrared sensing and imagingcitations
- 2017Large-Area MEMS Tunable Fabry-Perot Filters for Multi/Hyperspectral Infrared Imagingcitations
- 2016Investigation of Thermal Expansion Effects on Si-Based MEMS Structurescitations
- 2016Preparation and characterization of cerium substituted bismuth dysprosium iron garnets for magneto-optic applicationscitations
- 2014Characterization of mechanical, optical and structural properties of bismuth oxide thin films as a write-once medium for blue laser recordingcitations
- 2014Characterization of mechanical, optical and structural properties of bismuth oxide thin films as a write-once medium for blue laser recording
- 2014Investigation of cerium-substituted europium iron garnets deposited by biased target ion beam depositioncitations
- 2009Elasto-plastic characterisation of low-temperature plasma-deposited silicon nitride thin films using nanoindentationcitations
- 2007Dielectric thin films for MEMS-based optical sensorscitations
- 2006Stress in low-temperature plasma enhanced chemical vapour deposited silicon nitride thin filmscitations
- 2005Determination of mechanical properties of silicon nitride thin films using nanoindentationcitations
- 2005Effects of deposition temperature on the mechanical and physical properties of silicon nitride thin filmscitations
- 2004Evaluation of elastic modulus and hardness of thin films by nanoindentationcitations
Places of action
Organizations | Location | People |
---|
article
Application of a Microfabricated Microwave Resonator in a Co-Pd-Based Magnetic Hydrogen-Gas Sensor
Abstract
We investigate the ferromagnetic resonance (FMR) response of microfabricated microwave resonators loaded with small Co16Pd84 alloy rectangles. A major increase in the FMR signal-to-noise ratio is achieved by employing the microwave-resonator structure. A FMR peak shift similar to that of Co16Pd84 continuous films is measured in the presence of hydrogen gas in the sample environment. We show that the very high sensitivity of the FMR signal of the Co16Pd84 alloy rectangle to hydrogen exposure can be used to measure relatively small hydrogen-concentration steps near 100% H2. Additionally, we also demonstrate that this structure can measure hydrogen over a concentration range from 3% to 100% H2 in N2. In time-dependent FMR measurements, we discover a temperature dependence of the FMR signal, which we relate to intrinsic temperature-dependent changes in saturation magnetization and the magnetic anisotropy of the Co-Pd alloy.