| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
González Cuervo, Claudia Paulina
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (16/16 displayed)
- 2019Removal of cadmium in wastewater through geopolymeric materials based on pumice.citations
- 2017Inclusion of geopolymers derivate from fly ash and pumice in reinforced concrete
- 2017Structural and mechanical study of concrete made from cementitious materials of low environmental impactcitations
- 2017Characterization of Tungsten Carbide coatings deposited on AISI 1020 steelcitations
- 2016Changes on electrical and structural properties of polyaniline and polypyrrol by mullite doping
- 2016Morphological analysis of carbon steels using fractal geometry
- 2014Synthesis and characterization of inorganic polymers from the alkali activation of an aluminosilicatecitations
- 2013Comparative study between structural and electrical properties of geopolymers applied to a green concretecitations
- 2013Conducting polymers doped with a mineral phase
- 2012Synthesis, characterization and ac-conductivity measurements of polyaniline based composites with fly-ash and clinker
- 2008The effect of Mn and B on the magnetic and structural properties of nanostructured Fe60Al40 alloys produced by mechanical alloying
- 2008Comparative study between melted and mechanically alloyed samples of the Fe50Mn10Al40 nanostructured systemcitations
- 2003Bulk Magnetic Properties of the Fe0.5Mn0.1Al 0.4 Disordered Alloycitations
- 2003Mössbauer and X-Ray Characterization of Fe0.2Mn 0.4Al0.4 Mechanically Alloyed Powders
- 2003Magnetic and Structural Properties of Fe-Mn-Al Alloys Produced by Mechanical Alloyingcitations
- 2001Magnetic phase diagram of the FexMn0.60-xAl0.40 (0.20≤x≤0.60) alloys mechanically alloyed for 48 hours
Places of action
| Organizations | Location | People |
|---|
article
Synthesis and characterization of inorganic polymers from the alkali activation of an aluminosilicate
Abstract
<p>This paper presents the results of the synthesis and characterization of inorganic polymers (IP) from aluminosilicates: bentonite (BT) and pumice (PP). The synthesis of IP, was carried out by two methods involving alkaline activation, at room temperature and 80 ± 5 °C, using as activating agent sodium silicate both commercial and analytical (Na<sub>2SiO</sub>3). Sodium hydroxide (NaOH) at 3 M, 7 M and 12 M was added. A lower degree of polymerization was obtained by using analytical precursors subjected to room temperature and 80 ± 5°C. Replacement of heating by the use of the commercial activating agent with greater alkalinity allows the formation of a 3D network. The materials were structurally characterized by FTIR spectroscopy with Attenuated Reflectance (ATR), Scanning Electron Microscope (SEM) and X -ray diffraction (DRX).</p>