693.932 PEOPLE
| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Nor, Nik Hisyamudin Muhd
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (11/11 displayed)
- 2017Optimization of the EMI shielding effectiveness of fine and ultrafine POFA powder mix with OPC powder using Flower Pollination Algorithmcitations
- 2017Effects of Annealing Time on Electrodeposited-n-Cu2O Thin Film
- 2017Effect of triggering angles on the crushing mechanisms of hybrid woven kenaf/aluminum hollow cylinders
- 2017Effect of Rotating Mold Speed on Microstructure of Al LM6 Hollow Cylinder Fabricated Using Centrifugal Methodcitations
- 2017Deflection of elastic beam with SMA wires eccentrically insertedcitations
- 2017Cyclic Voltammetry Measurement for Cu2O Based Homostructure Thin Filmcitations
- 2017Residual stresses in shape memory alloy fiber reinforced aluminium matrix compositecitations
- 2016Fracture toughness of woven kenaf fibre reinforced compositescitations
- 2013Decision Making With the Analytical Hierarchy Process (AHP) for Material Selection in Screw Manufacturing for Minimizing Environmental Impactscitations
- 2013Feasibility Study of Waste Motor Recycling through Manual Dismantling and Hydrometallurgical Processcitations
- 2013Decision Making of Screw Manufacturing for the Best Environmental and Economic Combination by Using AHPcitations
Places of action
| Organizations | Location | People |
|---|
article
Deflection of elastic beam with SMA wires eccentrically inserted
Abstract
This research is intended to investigate the ability of shape memory alloys (SMA), through its activation, in generating loads to control beam deflection. An elastic beam is formed by sandwiching eccentrically SMA wires between two elastic plates. SMA wires are activated by electrical current from the power supply. Laser displacement meter (LDM) is used to measures deflection of sample. Results show that the deflection of the beam is dependent on the temperature change. The temperature-deflection response also shows the existence of hysteresis.