• Vierelä, R.
• Kaijalainen, A.
• Plosila, P.
• Rautio, P.
• Kesti, V.
• Kömi, J.

Abstract

<jats:title>Abstract</jats:title><jats:p>One limitation of the standardized ISO 16630 hole expansion test is that it provides only one result: limiting hole expansion ratio (HER). In practice, steels with similar HER values can have different cut edge forming behavior due to possible differences in strain localization tendencies. Digital image correlation (DIC) strain measurement during formability testing allows more in-detail analysis of strain-state near the cut edge. In this paper, strain evolution during hole expansion testing was investigated for three 800 MPa tensile strength grade hot-rolled strip steels. The steels were selected to have differences in microstructures and anisotropies of mechanical properties. Two different hole expansion test methods with DIC strain measurement were utilized to investigate different edge loading scenarios: in-plane stretching with a flat-top punch and more out-of-plane stretching with a hemispherical punch. Test holes were prepared according to ISO 16630 standard. In order to examine strain evolution and localization during testing, strains were measured with circle-shape sections around the hole in various distances from the cut edge. Strain localization behavior was investigated in different sheet directions and the effect on the hole expansion ratio was evaluated. Results show considerable differences in the cut edge forming behavior between the investigated materials.</jats:p>

Topics

• impedance spectroscopy
• microstructure
• strength
• steel
• forming
• tensile strength