| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
González Cuervo, Claudia Paulina
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (16/16 displayed)
- 2019Removal of cadmium in wastewater through geopolymeric materials based on pumice.citations
- 2017Inclusion of geopolymers derivate from fly ash and pumice in reinforced concrete
- 2017Structural and mechanical study of concrete made from cementitious materials of low environmental impactcitations
- 2017Characterization of Tungsten Carbide coatings deposited on AISI 1020 steelcitations
- 2016Changes on electrical and structural properties of polyaniline and polypyrrol by mullite doping
- 2016Morphological analysis of carbon steels using fractal geometry
- 2014Synthesis and characterization of inorganic polymers from the alkali activation of an aluminosilicatecitations
- 2013Comparative study between structural and electrical properties of geopolymers applied to a green concretecitations
- 2013Conducting polymers doped with a mineral phase
- 2012Synthesis, characterization and ac-conductivity measurements of polyaniline based composites with fly-ash and clinker
- 2008The effect of Mn and B on the magnetic and structural properties of nanostructured Fe60Al40 alloys produced by mechanical alloying
- 2008Comparative study between melted and mechanically alloyed samples of the Fe50Mn10Al40 nanostructured systemcitations
- 2003Bulk Magnetic Properties of the Fe0.5Mn0.1Al 0.4 Disordered Alloycitations
- 2003Mössbauer and X-Ray Characterization of Fe0.2Mn 0.4Al0.4 Mechanically Alloyed Powders
- 2003Magnetic and Structural Properties of Fe-Mn-Al Alloys Produced by Mechanical Alloyingcitations
- 2001Magnetic phase diagram of the FexMn0.60-xAl0.40 (0.20≤x≤0.60) alloys mechanically alloyed for 48 hours
Places of action
| Organizations | Location | People |
|---|
article
Structural and mechanical study of concrete made from cementitious materials of low environmental impact
Abstract
<p>This work shows the results obtained by replacing Type I Portland®, by cementitious geopolymers materials, derived from minerals, in concrete mixtures. Synthesis of both geopolymers through alkaline activation of two alluminosilicates: Bentonite and Pumice with sodium silicate (Na<sub>2</sub>SiO<sub>3</sub>). XRD, SEM and XRDE are used to structural study of new geopolymers. Concrete mixtures with replacement of Portland have 10% and 30% of geopolymer. Finally, concrete mortars formed were mechanically analysed according to ICONTEC 220 at 7, 14, 28, 41, 90 and 120 days of cure. Results shows that compressive strength of concrete from Bentonite and Pumice are almost the same for the standard concrete at 28 days of cure. At 90 days of cure, compression resistance of concrete from Pumice at 10% is even higher than those that standard concrete shows.</p>