| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Abrahamsen, Asger Bech
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (19/19 displayed)
- 2023Corrosion surface morphology-based methodology for fatigue assessment of offshore welded structurescitations
- 2018Two level undercut-profile substrate-based filamentary coated conductors produced using metal organic chemical vapor depositioncitations
- 2018Optimal design of galvanic corrosion protection systems for offshore wind turbine support structurescitations
- 2017Potential of Partially Superconducting Generators for Large Direct-Drive Wind Turbinescitations
- 2017The Effect of Nano-TiC Addition on Sintered Nd-Fe-B Permanent Magnetscitations
- 2017The Effect of Nano-TiC Addition on Sintered Nd-Fe-B Permanent Magnetscitations
- 2017Topology Comparison of Superconducting Generators for 10-MW Direct-Drive Wind Turbines: Cost of Energy Basedcitations
- 2015Potential of MgB 2 superconductors in direct drive generators for wind turbines
- 2015Effects of an electromagnetic shield and armature teeth on the short-circuit performance of a direct drive superconducting generator for 10 MW wind turbinescitations
- 2015Potential of MgB2 superconductors in direct drive generators for wind turbines
- 2012Large superconducting wind turbine generatorscitations
- 2012Critical current density measurement of thin films by AC susceptibility based on the penetration parameter hcitations
- 2010Influence of the initial Bi2223 phase content on microstructure development in Bi2223/Ag tapescitations
- 2010Anisotropy of the critical current in MgB2 tapes made of high energy milled precursor powdercitations
- 2009Modeling flux pinning in thin undoped and BazRo3-doped YBCO filmscitations
- 2009Design study of 10 kW superconducting generator for wind turbine applicationscitations
- 2009Design study of 10 kW superconducting generator for wind turbine applicationscitations
- 2003Possible magnetism in vortex cores of superconducting TmNi2B2C studied by small angle neutron scattering
- 2003Possible magnetism in vortex cores of superconducting TmNi 2 B 2 C studied by small angle neutron scattering
Places of action
| Organizations | Location | People |
|---|
article
Influence of the initial Bi2223 phase content on microstructure development in Bi2223/Ag tapes
Abstract
(Bi,Pb)2Sr2Ca2Cu3O10 (Bi2223) Ag-sheathed tapes were produced from precursors containing various amounts of pre-reacted Bi2223 phase obtained by means of controlled calcinations of the starting powder mixture. The evolution of the critical current density during the first 20h of the first heat treatment follows closely that of the Bi2223 phase content. A maximum rate of increase is observed for precursor powders initially containing a small amount of Bi2223. The crystallinity of the Bi2223 phase along its c-axis improves with sintering time and is better in the tapes manufactured with precursor powders containing the largest amount of prereacted Bi2223. While the degree of preferential orientation of the Bi2223 phase at the Ag/ceramic core interface is not influenced by the initial Bi2223 phase content, the average texture in the ceramic core worsens with the increase of initial Bi2223 phase content. This effect is likely to play a role in the limited performance of Bi2223-rich precursors.