| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Noh, Mohamad Zaky
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (8/8 displayed)
- 2021Mechanical Strength of Concrete by Replacement of Sand with Porcelain Waste with Addition of Superplasticizer
- 2020Effect of Sintering Temperature on Properties of Setiu Clay Sediments
- 2019Preparation and characterization of ceramic membrane by using palm fibers as pore forming agentcitations
- 2018Crystalline Phase, Surface Morphology and Electrical Properties of Monovalent Doped Pr0.75Na0.25Mn1-yCoyO3 Ceramics
- 2016The Hardness Properties of Porcelain with Substitution of Quartz by Rice Husk Ash at Different Soaking Timecitations
- 2013Effect of Operating Temperature on Direct Recycling Aluminium Chips (AA6061) in Hot Press Forging Processcitations
- 2013Effect of Mica Content on the Physical, Mechanical and Morphological Properties of Alumina-Cullet-Mica Ceramiccitations
- 2007CORRELATION BETWEEN THE BENDING STRENGTH AND THE THICKNESS INTERLAYER OF ALUMINA-MILD STEEL FRICTION WELDED AT LOWER ROTATIONAL SPEED
Places of action
| Organizations | Location | People |
|---|
document
Preparation and characterization of ceramic membrane by using palm fibers as pore forming agent
Abstract
Ceramic membranes captured much attention due to the chemical and thermal stability, and high separation efficiency. In this study, the ball clay ceramic membranes were prepared with slip casting method. Palm fibres in range of 0 wt.% to 40 wt.% were used as pore forming agent. Membranes produced were characterized by using Archimedes Method and Universal Testing machine for porosity and density, and compressive strength, respectively. While Scanning Electron Microscopy was used to observe the morphology of the ceramic membrane. As the amount of palm fibres increase from 0 wt.% to 40 wt.%, the porosity was found increasing from 36% to 54%, while the density and compressive strength were decreasing with 2.5 g/cm3 to 1.7 g/cm3, and 8.37 MPa to 1.42 MPa, respectively. Therefore, the amount of palm fibres greatly influence the properties of ceramic membrane. These ceramic membranes are highly potential to be applied for filtration test due to high in porosity value over 40%.