693.932 PEOPLE
| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Oniszczuk-Świercz, Dorota
Warsaw University of Technology
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (7/7 displayed)
- 2022Experimental Investigation and Optimization of Rough EDM of High-Thermal-Conductivity Tool Steel with a Thin-Walled Electrodecitations
- 2022Experimental Investigation of Technological Indicators and Surface Roughness of Hastelloy C-22 after Electrical Discharge Machining Using POCO Graphite Electrodescitations
- 2020Experimental investigation of influence wedm parameters on surface roughness and flatness deviationcitations
- 2019The Effects of Reduced Graphene Oxide Flakes in the Dielectric on Electrical Discharge Machiningcitations
- 2019Investigation of the Influence of Reduced Graphene Oxide Flakes in the Dielectric on Surface Characteristics and Material Removal Rate in EDMcitations
- 2018Optimization of machining parameters of electrical discharge machining tool steel 1.2713citations
- 2017Influence of electrical discharge pulse energy on the surface integrity of tool steel 1.2713
Places of action
| Organizations | Location | People |
|---|
document
Optimization of machining parameters of electrical discharge machining tool steel 1.2713
Abstract
In this paper, the influence of the input EDM parameters on the surface quality of tool steel 1.2713 has been modelledand optimised.Experimentalstudies wereconductedwith a designexperiments(DOE)techniques.Basedon the result of experimentalinvestigation influence of EDM parameter:discharge current, time discharge and timeinterval ontheroughness Raandmaterialremovalrate wereestablishedusingresponsesurfacemethodology.Consideringthe properties of the EDM for the roughness Rain the range between 1-2 μm with the maximum possiblevalue of the MRRprocess optimizationwas conducted based on desirability technique.