| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Corney, Jonathan
University of Edinburgh
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (13/13 displayed)
- 2020Process selection methodology for near net shape manufacturingcitations
- 2019A state of the art review of hydroforming technologycitations
- 2018Design and validation of a fixture for positive incremental sheet formingcitations
- 2018Enabling sheet hydroforming to produce smaller radii on aerospace nickel alloyscitations
- 2018Realising the affective potential of patentscitations
- 2017Correlation between von Mises strain and material thinning in a hydroformed sample of Ti35A aerospace grade titaniumcitations
- 2017A methodology for near net shape process feasibility assessmentcitations
- 2017A methodology for assessing the feasibility of producing components by flow formingcitations
- 2016A methodology for assessing the feasibility of producing components by flow forming
- 2016Flow forming
- 2015Assessing the potential benefits of manufacturing gas turbine components by utilizing hydroforming technology
- 2015Systematic process selection for cold forging
- 2015A review of flow forming processes and mechanismscitations
Places of action
| Organizations | Location | People |
|---|
document
Correlation between von Mises strain and material thinning in a hydroformed sample of Ti35A aerospace grade titanium
Abstract
<p>This paper presents the results of an experimental investigation of the strain measured on a sample of Ti35A (commercially pure) titanium that was formed past the point of failure in a hydroforming operation. The sample was etched prior to forming to allow for a strain map of the exterior to be created and examined by using a circle grid analysis (CGA) technique. The sample was scanned post forming with precise optical inspection to ascertain an accurate model of its geometry. This paper discusses the results of the analyses including the full geometric and surface strain measurements. This paper then compares material thinning properties to strain values and finds a linear relationship of approximately 3:1 between Von Mises strain and material thinning percentage throughout the sample. The slope of the line appears to correlate strongly with the material's Poisson's ratio and could have potential uses in process planning.</p>