| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Alias, Afishah
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (12/12 displayed)
- 2020Structural and Optical Properties of ZnO and MgZnO Semiconductor Materials at Different Annealing Temperature
- 2018Electrical simulation of different photoactive layer thickness on organic heterojunction solar cellcitations
- 2017Frequency and voltage dependent electrical responses of poly(triarylamine) thin film-based organic Schottky diodecitations
- 2017The Structural and Optical Properties of Poly(Triarylamine) (PTAA) Thin Films Prepared at Different Spin Rate Using Spin Coating Methodcitations
- 2016Annealing heat treatment of Poly(triarylamine) (PTAA) thin films deposited using spin coating
- 2015GROWTH CHARACTERISTIC OF GZO FILM FABRICATED BY RF MAGNETRON SPUTTERING
- 2015Structural properties 3,16-bis triisopropylsilylethynyl (pentacene) (TIPS-pentacene) thin films onto organic dielectric layer using slide coating method
- 2015PREPARATION AND CHARACTERIZATION OF CARBON NANOFIBERS / METAKAOLIN GEOPOLYMER BASED NANOCOMPOSITE
- 2015Fabrication and characterization of 6,13-bis(triisopropylsilylethynyl)-pentacene active semiconductor thin films prepared by flow-coating methodcitations
- 2015EFFECT OF SPUTTERING PRESSURE ON THE STRUCTURAL AND OPTICAL PROPERTIES OF ZNO FILMS DEPOSITED ON FLEXIBLE SUBSTRATEcitations
- 2013Effect of [6,6]-Phenyl-C 61 butyric acid methyl ester (PCBM) agglomerated nanostructure on device performance in organic thin-film transistorscitations
- 2011Fabrication of ZnO Thin-Film Transistors by Chemical Vapor Deposition Method using Zinc Acetate Solutioncitations
Places of action
| Organizations | Location | People |
|---|
document
Fabrication and characterization of 6,13-bis(triisopropylsilylethynyl)-pentacene active semiconductor thin films prepared by flow-coating method
Abstract
Investigation on the physical characterization and comparison of organic thin film based on a soluble 6,13-bis(triisopropylsilylethynyl) (TIPS) pentacene is reported. Oriented thin-films of pentacene have been successfully deposited by flow-coating method, in which the chloroform solution is sandwiched between a transparent substrate and a slide glass, followed by slow-drawing of the substrate with respect to the slide glass. Molecular orientation of flow-coated TIPS-pentacene is comparable to that of the thermal-evaporated pentacene thin film by the X-ray diffraction (XRD) results. XRD results showed that the morphology of flow-coated soluble pentacene is similar to that of the thermal-evaporated pentacene thin films in series of (00l) diffraction peaks where the (001) diffraction peaks are strongest in the nominally out-of-plane intensity and interplanar spacing located at approximately 2θ = 5.33° (d-spacing, d001 = 16 A). Following that, ITO/p-TIPS-pentacene/n-ZnO/Au vertical diode was fabricated. The diode exhibited almost linear characteristics at low voltage with nonlinear characteristics at higher voltage which similar to a pn junction behavior. The results indicated that the TIPS-pentacene semiconductor active thin films can be used as a hole injection layer for fabrication of a vertical organic transistor.