• Feilzer, Albert J.
• Jpm, Tribst
• Piva, Amanda Maria De Oliveira Dal
• Kleverlaan, Cornelis J.
• Bierman, Thera Elisa
• Lu, Yuqing

Abstract

<jats:title>Abstract</jats:title><jats:p>Objectives The aim of the study was to evaluate the effect of surface treatment and resin cement on the bond strength of conventional and advanced lithium disilicates (ALDs).</jats:p><jats:p>Materials and Methods Ceramic slices (2 × 13 × 15 mm) of conventional lithium disilicate (LD) (IPS e.max CAD) and ALD (CEREC Tessera) were sectioned, polished, and divided into 16 groups (n = 10) according to the factors: ceramic, surface treatment, and resin cement (Panavia V5 and Variolink Esthetic DC). Surface treatments consisted of hydrofluoric acid 4.9% etching for 20 seconds (Hf20) or 30 seconds (Hf30), self-etching ceramic primer (Se), and sandblasting (Sb). Then, a resin cement cylinder (Ø = 2.5 mm) was manufactured on each specimen's surface. The specimens were then submitted to a shear bond strength (SBS) test. Surface roughness was evaluated through a contact profilometer, and surface morphology was evaluated under scanning electron microscopy for qualitative analysis.</jats:p><jats:p>Statistical Analysis Two-way analysis of variance (ANOVA) was used to analyze the data of SBS and surface roughness. For bond strength, the effects of surface treatment, resin cement, and the interaction were analyzed for each ceramic. For roughness, analyzed factors include ceramic and surface treatment.</jats:p><jats:p>Results ANOVA revealed that ceramic (p = 0.047) and surface treatment (p &lt; 0.001) factors affected the bond strength, while the cements performed similarly. Both materials showed adequate bond strength (ALD 19.1 ± 7.7 MPa; LD 17.1 ± 7.9 MPa). Sb protocol showed the lowest mean value (9.6 ± 2.9 MPa) compared with Hf20 (22.0 ± 7.1 MPa), Hf30 (21.7 ± 7.4 MPa), and Se (19.3 ± 6.0 MPa).</jats:p><jats:p>Conclusion For both ceramics, the highest performance was obtained after applying Se and Hf20 or Hf30. Therefore, longer etching time is unnecessary. Sb protocol must be avoided.</jats:p>

Topics

• impedance spectroscopy
• morphology
• surface
• scanning electron microscopy
• strength
• cement
• etching
• Lithium
• ceramic
• resin
• collision-induced dissociation