| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Zulkipli, Muhammad
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (8/8 displayed)
- 2019The open air electrical-field activated sintering and forming of micro components.
- 2017Electrical-Field Activated Sintering and Forming of Micro-Components
- 2017Forming of Miniature Components from Powders by Combining Field-Activated Sintering and Micro-Formingcitations
- 2016Fabrication of Micro Components with MSZ Material Using Electrical-Field Activated Powder Sintering Technology
- 2016Forming Alumina (Al2O3) by Micro-FAST
- 2015Forming of micro-components by electrical-field activated sinteringcitations
- 2015Fabrication of NiTi shape memory alloy by Micro-FASTcitations
- 2015Forming of titanium and titanium alloy miniature-cylinders by electrical-field activated powder sintering and formingcitations
Places of action
| Organizations | Location | People |
|---|
document
Forming of titanium and titanium alloy miniature-cylinders by electrical-field activated powder sintering and forming
Abstract
As demands on miniature products increase significantly, a rapid process and production system for high-throughput, highly flexible and cost-efficient volume production of miniaturised components made from a wide range of materials is needed. A novel and electrical-field-activated sintering and forming process shows the potential to produce solid parts from powder material without any binder. Using titanium (Ti) and titanium alloy (90Ti10Sn) powder material, several processing parameters have been investigated, such as pressure, heating rate, heating temperature and holding time, which helped to contribute to the optimum result. In this study, using graphite dies, graphite punches and tungsten carbide punches, solid samples were produced, having a cylinder shape of Ø4.00 mm × 4.00 mm. Several properties of the solid Ti and 90Ti10Sn samples, such as density, hardness and the microstructures, were examined, and these showed that good results have been obtained.