693.932 PEOPLE
| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Leppäniemi, Jaakko
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (11/11 displayed)
- 2020Printed, Highly Stable Metal Oxide Thin-Film Transistors with Ultra-Thin High-κ Oxide Dielectriccitations
- 2020Printed, Highly Stable Metal Oxide Thin-Film Transistors with Ultra-Thin High-κ Oxide Dielectriccitations
- 2015Gravure printed sol-gel derived AlOOH hybrid nanocomposite thin films for printed electronicscitations
- 2015Gravure printed sol-gel derived AlOOH hybrid nanocomposite thin films for printed electronicscitations
- 2014Sintering of inkjet printed silver tracks with boiling salt watercitations
- 2014Modelling of printable metal-oxide TFTs for circuit simulation
- 2012Water-based carbon-coated copper nanoparticle fluid:Formation of conductive layers at low temperature by spin coating and inkjet depositioncitations
- 2012Water-based carbon-coated copper nanoparticle fluidcitations
- 2010Substrate-facilitated nanoparticle sintering and component interconnection procedurecitations
- 2010Electrical Sintering of Conductor Grids for Optoelectronic Devices
- 2010Printable WORM and FRAM memories and their applications
Places of action
| Organizations | Location | People |
|---|
article
Sintering of inkjet printed silver tracks with boiling salt water
Abstract
This paper demonstrates a simple two-step method tosinter inkjet printed silver tracks with boiling saltwater. As the temperature during the sintering processstays at 110 degrees Celsius, the method is compatiblewith most polymer substrates. UV light is used to enhanceadhesion between the printed silver layer and thesubstrate film to prevent delamination of silver tracksduring salt water treatment. After 20 min immersion inboiling salt water, the printed silver lines exhibitelectrical resistivity only two times higher than thebulk silver value as measured using a four wireresistance meter