| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Gonzalez, Ivan
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (2/2 displayed)
- 2023Influence of MnS inclusion characteristics on generation of white etching cracks in 100Cr6 bearing steelcitations
- 2022Development of a new, fully automated system for electron backscatter diffraction (EBSD)-based large volume three-dimensional microstructure mapping using serial sectioning by mechanical polishing, and its application to the analysis of special boundaries in 316L stainless steelcitations
Places of action
| Organizations | Location | People |
|---|
article
Influence of MnS inclusion characteristics on generation of white etching cracks in 100Cr6 bearing steel
Abstract
<p>Wind turbine gearbox (WTGB) bearings suffer from premature failures through white etching cracks (WECs). To investigate causes of this failure mechanism, we tested two types of 100Cr6 bearing steel components. We carried out rolling contact fatigue experiments on standard washers and material extracted from a WTGB bearing. These differed strongly in morphology and orientation of non-metallic inclusions (NMIs) with respect to the raceway, especially of MnS-type. While the standard washer did not exhibit WECs formation, the WTGB bearing did - even under moderate conditions (1.9 GPa Hertzian pressure, 10<sup>7</sup> cycles). We therefore conclude that MnS-inclusions are a key factor in initiation of WECs in WTGB bearings.</p>