| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Gódor, István
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (4/4 displayed)
- 2014Tribological performance of forged steel and cast iron crankshafts on model scale
- 2013Applicability of ring-on-disc and pin-on-plate test methods for Cu-steel and Al-steel systems for large area conformal contactscitations
- 2012Tribological functionality of aluminium sliding materials with hard phases under lubricated conditionscitations
- 2010Tribologische funktionsweise von ungefüllten und gefüllten TPU-dictungsmaterialen - Ein erfahrungsbericht
Places of action
| Organizations | Location | People |
|---|
article
Tribological functionality of aluminium sliding materials with hard phases under lubricated conditions
Abstract
<p>This paper describes the tribological functionality of hypereutectic AlSi under conformal contact conditions. Temperature and load bearing tests were performed with a ring-on-disc configuration with steel counterparts under fully formulated engine oil. Tribometric tests show significantly higher wear resistance and loadability of AlSi compared to pure Al. Post test surface characterization by light and electron microscopy revealed the load bearing functionality of the Si hard phases. Selective formation of protective tribofilms was observed exclusively on these Si particles and on the corresponding steel counterpart. This formation requires sufficient energy input and only takes place under harsh contact conditions.</p>