• Price, Dennis
• Desmulliez, Mpy
• Bernassau, Anne L.
• Beadel, Matthew
• Flynn, David
• Jones, Thomas David Arthur

Abstract

The deposition of increased volumes of Cu down an interconnect through-hole via (THV) of a Printed Circuit Board (PCB) is highly desirable for the fabrication of increasing component density and PCB stacks. A quality metric, called micro-throwing power, characterises the volume of Cu that can be deposited within a THV. In this paper, we analyse the influence of 1 ± 0.05 MHz megasonic (MS) assisted agitation applied to copper (Cu) electroplating baths on the micro-throwing ability of a standard, non-filling Cu electroplating solution. Our results indicate that megasonic agitation is shown to increase the Cu deposition volume within a THV by 45% for an increase of MS pressure from 225 W to 450 W, highlighting the significance of acoustic pressure as a key parameter to control MS THV plating volume. Bulk fluid flow rate within a 500 L plating tank is shown to increase by 150% due to Eckhart acoustic streaming mechanisms, compared to existing bath agitation techniques and panel movement. From MS plating experiments and COMSOLTM finite element acoustic scattering simulations, transducer orientation is shown to influence plating performance, with higher-order acoustic resonant modes forming within THVs identified as the cause. Simulations indicate that higher potential acoustic energy was coupled into a 0.200 mm diameter THV cavity, width-to-length aspect ratio (ar): 8:1, than a larger cavity of diameter 0.475 mm, ar 3.4:1. The maximum acoustic energy coupled into THV cavity is observed for a wavefront propagating along the axis of the cavity entrance, indicating an ideal alignment for the MS plating setup.

Topics

• density
• impedance spectroscopy
• experiment
• simulation
• mass spectrometry
• copper
• ultrasonic
• forming
• electrodeposition