| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Jackson, Timothy
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (12/12 displayed)
- 2015Influence of Uncertainty in Dielectric Properties on the Design Performance of a Tunable Composite Right/Left Handed Leaky Wave Antenna
- 2014Uncertainties in the permittivity of thin films extracted from measurements with near field microwave microscopy calibrated by an image charge modelcitations
- 2012Line defects, planar defects and voids in SrTiO3 films grown on MgO by pulsed laser and pulsed laser interval depositioncitations
- 2010Microstructural investigation of strontium titanate films grown by interval pulsed laser depositioncitations
- 2009Two-dimensional growth of SrTiO3 thin films on (001) MgO substrates using pulsed laser deposition and reflection high energy electron diffractioncitations
- 2009Comparison of structural, microstructural, and electrical analyses of barium strontium titanate thin filmscitations
- 2008Growth and Microstructural Studies of Strontium Titanate Films Grown by Standard and Interval Pulsed Laser Depositioncitations
- 2006Microstructure of Homeoepitaxial SrTiO₃ Thin Films Grown by Laser Ablationcitations
- 2006Temperature Dependent Dielectric Properties of Coplanar Phase Shifters Fabricated from Ba₀.₅SR₀.₅Ti0₃ Thin Filmscitations
- 2006Microwave and Microstructural Properties of Ba₀.₅Sr₀.₅TiO₃ of Thin Film Coplanar Phase Shifterscitations
- 2004Holes in YBa₂Cu₃0₇₋x Thin Films on Vicinal Strontium Titanate Substratescitations
- 2004Growth, Microwave Properties and Microstructure of Ba₀₊₀₅Sr₀₊₉₅TiO₃ Thin Filmscitations
Places of action
| Organizations | Location | People |
|---|
article
Line defects, planar defects and voids in SrTiO3 films grown on MgO by pulsed laser and pulsed laser interval deposition
Abstract
Two and three dimensional growth of SrTiO3 films on (001) MgO substrate was achieved by pulsed laser interval and pulsed laser deposition respectively. The growth mode was monitored by in-situ reflection high energy electron diffraction. Interval deposition forces layer-by-layer growth of materials even with such a large lattice misfit (similar to 7.9%). A titanium dioxide buffer monolayer was deposited to allow the film to wet the substrate to encourage two dimensional growth of the strontium titanate. A variety of defects was investigated using transmission electron microscopy and high resolution scanning transmission electron microscopy. Misfit dislocations, steps at the interface, Ti-rich defects and regularly shaped nano-holes connected by anti-phase boundaries were found to be the dominant defects in these films grown layer by layer. The edges of the nano-holes were mainly along [010] and 1100] for a [001] growth direction. The large strain between the two crystal systems with large lattice mismatch leads to in-plane tensile stress during the layer-by-layer growth. The stress is relieved in part by the holes. The films with a three dimensional growth mode possess a uniform surface with dislocations as the dominant defects. The individual densities of the various defects, including a Ti-rich phase and misfit and threading dislocations, are determined by the kinetics of the deposition method. (C) 2011 Elsevier B.V. All rights reserved.