| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Suppan, Clemens
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (3/3 displayed)
- 2021Microstructure and mechanical properties of partially ferritic Q&P steelscitations
- 2021Influence of partitioning parameters on the mechanical stability of austenite in a Q&P steel: A comparative in-situ studycitations
- 2020Characterization of carbides in Q&P steels using a combination of high-resolution methodscitations
Places of action
| Organizations | Location | People |
|---|
article
Influence of partitioning parameters on the mechanical stability of austenite in a Q&P steel: A comparative in-situ study
Abstract
The transformation-induced plasticity (TRIP)-effect is an efficient way to increase the formability in high performance steels. Hence, an optimal stability of the retained austenite is crucial to benefit the most from this effect. In the present work, in-situ high energy X-ray diffraction was used to study the austenite to martensite transformation upon uniaxial tensile loading of a TRIP-assisted steel produced by the quenching and partitioning (Q&P) process. A detailed analysis of the diffraction patterns recorded during deformation allowed to study the austenite stability with respect to the applied partitioning conditions. The austenite stability was found to strongly depend on the applied heat treatment, and could be mainly attributed to the carbon content and to the tempering degree of the surrounding martensitic matrix. Partitioning at 260 °C resulted in a poor austenite stability, while the austenite was almost too stable after partitioning at 360 °C. The optimal combination of strength and ductility was found for partitioning at 400 °C.The micromechanical behavior was analyzed by the evolution of individual lattice strains and the change of full width at half maximum (FWHM). Yielding of austenite could be clearly identified by an increase of FWHM. Martensite showed an unexpected peak narrowing upon yielding. In the case of 2-step Q&P, austenite started to yield after martensite, while yielding occurred almost simultaneously in the case of 1-step Q&P.