| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Grosjean, Christophe
Center for Technology & Innovation Management
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (4/4 displayed)
- 2022Susceptibility to Pitting and Environmentally Assisted Cracking of 17-4PH Martensitic Stainless Steel Produced by Laser Beam Meltingcitations
- 2022Effects of channel contour laser strategies on fatigue properties and residual stresses of laser powder bed printed maraging steel
- 2022Influence of hydrogen on the stress-relaxation properties of 17-4PH martensitic stainless steel manufactured by laser powder bed fusioncitations
- 2021Comparative study of the microstructure between a laser beam melted 17-4PH stainless steel and its conventional counterpartcitations
Places of action
| Organizations | Location | People |
|---|
article
Comparative study of the microstructure between a laser beam melted 17-4PH stainless steel and its conventional counterpart
Abstract
The aim of this work was to compare the microstructures of 17-4PH martensitic stainless steels (MSSs) obtained by conventional manufacturing (CM), and additive manufacturing (AM) using laser beam melting (LBM) process. Both materials were studied after the same H900 heat treatment. Significant differences in microstructure were observed between the two MSSs, with a higher austenite content for the AM-H900 sample, as compared to the CM-H900 sample. Transmission electron microscopy (TEM) analyses allowed to identify both retained and reversed austenite in the AM-H900 sample, but most part of the austenite detected was found to be reversed austenite. The high amount of reversed austenite in the AM-H900 sample was attributed to a heterogeneous distribution in austenite-stabilising elements in the solution heat treated AM sample, leading to a decrease in Ms value and subsequent increase in the driving force for the martensite to austenite transformation during the ageing at 480 °C. Moreover, TEM analyses highlighted thinner martensite laths for the AM-H900 steel as compared to the CM-H900 one. This was interpreted as an increase in both nucleation sites and growth rate for reversed austenite. Despite those differences in microstructure, the AM-H900 and CM-H900 samples showed similar tensile behaviour, with similar UTS and Rp0.2 values, but a decrease in the strain to fracture was observed for the AM-H900 sample, probably related to the pores and/or to intergranular carbides.