• Ohnuma, Masato
• Coakley, James
• Vorontsov, Vassili A.
• Dye, David
• Rahman, Khandaker M.

Abstract

<p>Tensile testing and cyclic tensile loading measurements were performed on heat-treated samples of annealed Ti-2448 and cold-rolled Ti-2448. Quenching from above the β-transus produces an alloy that is highly superelastic has ultra-low elastic modulus (10-25. GPa) and exhibits hysteresis on loading-unloading cycles. On repeated cycling the strain energy absorbed in each cycle decreases. Annealed Ti-2448 exhibits a stable hysteresis loop. Peaks from the α″ phase are observed in X-ray diffraction (XRD) patterns, thus the material is quite lean in β-stabilising additions. The alloy is shown to be highly unstable when heat-treated. A combination of small angle X-ray scattering (SAXS), transmission electron microscopy (TEM) and X-ray diffraction (XRD) was employed to relate the thermally induced microstructural evolution to the change in mechanical properties. A heat-treatment of 80. °C to the cold-rolled material precipitated the ω phase causing embrittlement. Increasing the ageing temperature from 80 to 300. °C increased the stiffness, made the elastic regime more linear, and further embrittled the alloy. The low temperature heat-treatments precipitate both ω and α″ phases. A higher temperature ageing treatment at 450. °C increased the yield strength to over 1. GPa and caused embrittlement, indicating co-precipitation of α and ω phases.</p>

Topics

• impedance spectroscopy
• phase
• x-ray diffraction
• strength
• transmission electron microscopy
• precipitate
• precipitation
• aging
• yield strength
• small angle x-ray scattering
• quenching