693.932 PEOPLE
| People | Locations | Statistics |
|---|---|---|
| Naji, M. |
| |
| Motta, Antonella |
| |
| Aletan, Dirar |
| |
| Mohamed, Tarek |
| |
| Ertürk, Emre |
| |
| Taccardi, Nicola |
| |
| Kononenko, Denys |
| |
| Petrov, R. H. | Madrid |
|
| Alshaaer, Mazen | Brussels |
|
| Bih, L. |
| |
| Casati, R. |
| |
| Muller, Hermance |
| |
| Kočí, Jan | Prague |
|
| Šuljagić, Marija |
| |
| Kalteremidou, Kalliopi-Artemi | Brussels |
|
| Azam, Siraj |
| |
| Ospanova, Alyiya |
| |
| Blanpain, Bart |
| |
| Ali, M. A. |
| |
| Popa, V. |
| |
| Rančić, M. |
| |
| Ollier, Nadège |
| |
| Azevedo, Nuno Monteiro |
| |
| Landes, Michael |
| |
| Rignanese, Gian-Marco |
|
Santos Vilaca Da Silva, Pedro
Aalto University
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (12/12 displayed)
- 2024A novel approach for zero material loss (zero flash) and uniform cross-section during friction stir welding of dissimilar thickness Cu and Al alloys
- 2024Characterization of friction stir-based linear continuous joining of aluminium alloy to structural polymercitations
- 2024Influence of sample extraction location on thermal desorption spectroscopy from a heat-resistant 13CrMo4-5 steel plate and correlation with microstructure featurescitations
- 2022Dissimilar friction stir welding of Al to non-Al metallic materials : An overviewcitations
- 2022Influence of copper plate positioning, zero tool offset, and bed conditions in friction stir welding of dissimilar Al-Cu alloys with different thicknessescitations
- 2022A review on friction stir-based channelingcitations
- 2019Fatigue behavior of MAG welds of thermo-mechanically processed 700MC ultra high strength steelcitations
- 2018Microstructural characterization of alloy 926 and 2205 duplex stainless steels coating layers deposited over high strength steel by friction surfacing
- 2017Effect of Microstructure on the Fatigue Behavior of a Friction Stirred Channel Aluminium Alloycitations
- 2017Effect of titanium on the weldability of thermomechanically rolled high-strength cold-formable steels
- 2010Friction stir welding of T-joints with dissimilar aluminium alloys: mechanical joint characterisationcitations
- 2009Mechanical and metallurgical characterization of friction stir welding joints of AA6061-T6 with AA6082-T6citations
Places of action
| Organizations | Location | People |
|---|
article
Dissimilar friction stir welding of Al to non-Al metallic materials : An overview
Abstract
<p>The paper presents a comprehensive review on dissimilar friction stir welding (FSW) of Al to non-Al metallic materials, wherein the combination of Al–Mg, Al–Cu, Al-steel and Al–Ti are covered. The summary revealed that FSW is observed as one of the most feasible solutions in the family of welding in case of dissimilar materials combinations of Al to non-Al metallic materials. The challenges such as the formation of intermetallic compounds, defects, and degradation of mechanical properties at the joint area are extensively managed in the case of dissimilar FSW compared to dissimilar conventional welding.</p>